Dental Resin Composite Heater

Features

According to your choice of material and personal preference temperature can be set up to: 40 degrees, 50 degrees and 70 degrees with 3 different indicators.
The temperature can be controlled by user.
Can also be used as a manual device for heating composite.
Easy handling.

Description

Dental Resin Composite Heater is designed to heat the composite resin material, improve the flow performance of the adhesive, and can also be used as a manual device for heating bonding.

AR Heat use the precision circuit control module to heat, control the temperature tolerance within 1 degree.

According to your choice of material and personal preference temperature can be set up to: 40 degrees, 50 degrees and 70 degrees.

SPECIFICATIONS

Output: 15V DC 2A
Power: 30W
Temperature setting: 40±1℃, 50±1℃, 70±1℃

TEMPERATURE	LIGHT COLOR	HEATING	Reach the undefined temperature
40°C	White	White LED glisten	White LED normally on
50°C	Green	Green LED glisten	Green LED normally on
70°C	Red	Red LED glisten	Red LED normally on

PRECAUTION:

The resin composite material must tight the lid of the syringe, prevent leakage material within the heating body.

CLEAN and DISINFECT:

All the parts can be cleaned with disinfectant dish cloth. Don’t put any parts immersed in any liquid cleaning and disinfection, don’t disinfect under high temperature and high pressure

Fault warning: 3 sets of indicator light glisten together: Temperature sensor failure.

1 x Resin composite heater
1 x Power adapter
Instruction manual

Directions For Use

STEP 1:

After connecting to 15V Direct Current, three indicator light (red, green and white) will be on. At that time, composite heater can be used.

STEP 2:

When users are using the heater, only the white light indicator lighter will be flashing, means the heater is working at 40o C. If you need to turn it off, push ON/OFF button again, (at that time, three indicator lights will be on) and the heater will stop heating.

STEP 3:

Three working mode ( 40°C/ 50°C/ 70°C) can be chose by users, according to their requirements.

STEP 4:

After choosing one working mode, (taking 40 C for example) the indicator light will keep flashing when the temperature is below 40 C. Otherwise, the light will keep lighting. At the same time, you can choose other heating mode. If without any action on it, the heater will be on standby after 30minutes.

STEP 5:

If you need to use it again, just push ON/OFF button again. And start to heating.

STEP 6:

The heater should be placed on smooth places.

STEP 7:

Injecting, heating resin composite material by syringes, the heating mode can be chose by the user.

Warranty

Manufacturer/Importer warranty of 3 months as applicable for this product.
Service and Warranty are handled by the manufacturer/importer directly for this product
Dentalkart will not be liable to replace the Products and the liability to replace any such Product is that of the Manufacturer/Importer
Dentalkart and the Buyer acknowledge that the Products purchased/usedare a subject matter of original Manufacturer/Importer’s warranties only
Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and Dentalkart may assist the customer in registering a request to get the Product replaced or serviced.
The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact or not altered in any manner or is not tampered as the case may be.