Bio-art Microjato Microblaster

Features

Bio–Art effective handy Microblaster is compact and easy to set up and use.

Micro-retentions.

Oxide removal.

Environment-friendly.

Adjustment of interproximal contacts.

Description

INTRODUCTION

Bio-art microblaster is a portable pneumatic device, easy to install and operate, designated to surface blasting, mainly in dental works.

The use of microblaster in dental clinic and dental laboratories has more and more been requested for being practical, ergonomic and accurate in small jobs and/or where the areas to be blasted has a slight contact with areas of preservation from blasting.

Bio-art microblaster is provided with an ejecting needle made of sintered carbide, which assures higher durability and accuracy during blasting.

Bio-art has developed three microblaster models depending on the purpose:

Microblaster standard and lab models one fixed nozzle mounted at a 138-degree angle.

Microblaster plus model two removable and autoclavable nozzles,mounted at 90 degree and 138 degree angles.

INDICATION:

Microjato standard

Micro-retentions;
Removal of cement from metal crowns, resin and other materials;
Internal cleaning of resin and ceramic “inlay-onlay”;
Metal or ceramic cleaning or degreasing when using the “intraoral ceramic repair” technique;
Occlusal blast for fine adjustment, replacing the use of carbon;
Internal evidence for adjustment and crown settling;
Adjustment of interproximal contacts;
Cleaning of castings;
Removal of oxidation.

TECHNICAL SPECIFICATIONS

Weight of microblaster standard and lab without the package- 65g

Weight of microblaster plus without the package- 70g

Weight of microblaster standard and lab with the package-210g

Weight of microblaster plus with the package- 215g

Package dimension (W x T x H) – 190 x 133 x 50mm

Work pressure – 60 a 80 lbf/pol (4-5,5 kgf/cm)

1 x Microblaster with fixed nozzle
1 x 40g Aluminum oxide
Instruction manual

Directions For Use

Remove the switch button clamp.

Microblaster plus model is provid4ed with two removable and autoclavable nozzles offering two options for the ejecting needle angling, one at 90 degrees ( indicated for intraoral work on posterior teeth) and another at 138 degree9 indicated for laboratory works and intraoral works on anterior teeth). According to the kind of work to be carried out, fix one of the nozzles on the microblaster body by means of the fixing nuts.

Fill the tank into a maximum of 3/4 of its capacity with aluminum oxide and fix it on the tank for abrasive lid located at the end of the microblaster body.

With the tank duly filled in and introduced in microblaster, press the switch button to start the blasting process.

Always try to keep a distance from 5 to 10mm between the face of the microblaster needle tip and the surface to be worked during blasting.

Warranty

Manufacturer/Importer warranty of 12 months as applicable for this product.

Service and Warranty are handled by the manufacturer/importer directly for this product
Deyo will not be liable to replace the Products and the liability to replace any such Product is that of the Manufacturer/Importer.

Deyo and the Buyer acknowledge that the Products purchased/used are a subject matter of original Manufacturer/Importer’s warranties only.

Any or all claims in relation to returns and replacement shall be made to the concerned Manufacturer/Importer only and Deyo may assist the customer in registering a request to get the Product replaced or serviced.

The Buyer acknowledges that the Products once sold will not be exchanged or taken back unless the seal of the package or the Product is intact or not altered in any manner or is not tampered as the case may be.